Problem
This application is an innovative sledge, the "Skionic", which allows you to ski sitting down. This makes the product a world's first. The structure can be controlled with the feet, while the inclination of the ski system is influenced by the hands. In a separate version suitable for the disabled, both the steering and the tilt can be controlled by the hands. Skionic is produced at an NGO/aid organisation in Lebanon (NGO is called arcenciel, see www.arcenciel.org).
The challenge lay in the bearing of the four rotary axes that the sledge has. Since high loads are placed on the system, the bearings should at the same time be compact as well as light, thin, easy to install, maintenance-free and efficient.
Solution
Today,
plain bearings made of iglidur G, are used on all four rotary axes, which combine all five requirements for compactness, lightness, thinness, ease of installation, freedom from maintenance and performance. Seven plain bearings are used for the four joints on one sledge: Two iglidur G flange bushings (GFI-1618-16) and one iglidur G glide bushing (GSI-1618-24) are used for the rotary axes of the rear ski joints. The manufacturer also relies on two iglidur G flange bushings (GFI-1618-16) for the rotary axis of the middle tilt lever, as well as an iglidur G flange bushing (GFI-1618-16) and a glide bushing (GSI-1618-16) for the rotary axis of the front ski. The version for the disabled uses the same plain bearings. Smaller plain bearings (GFI- or GSI-1214) are used for the children's version.
