ドライリンE 電動モーター

Stepper motors

• Powerful in 5 sizes
• Motors with metric connector or stranded wires
• Safety with encoder and brake
• With flattened motor shaft (D-Cut) for increased anti-rotation feature

DC motors

• Also available with protective housing
• Torques from 0.1 to 1.8Nm
• Speeds up to 440rpm
• With flattened motor shaft (D-Cut) for increased anti-rotation feature

EC/BLDC motors

• With Hall and encoder
• Sizes NEMA: 17, 23 and 34
• Virtually wear-free
• Very high speeds
• More cost-effective than conventional servomotors

Lead screw stepper motors

• 3 sizes with holding torque 0.1-2Nm
• 7 lead screw types with pitches from 0.8-50mm
• Matching lead screw nuts available
• Lead screw can be attached from both sides for stepper motor without encoder

Stepper motor with IP68 water protection

• Installation size: NEMA23/flange dimension 56mm
• Protection class - motor housing: IP68 (10m)
• Holding torque: 1.30Nm
• Rated current: 4.20A
• Motor connection: Terminal box

DC motor with worm gear

• With spline
• Space-saving & quiet
• Torques from 0.75Nm to 2.00Nm
• Speeds up to 350rpm
• Position encoder included

エキスパートツールをご使用いただくと、お客様の作業内容に適したモーターを数クリックで見つけることができます。ご希望の使用条件を入力してください。

Assemble the right electric motor with our linear system quickly and easily in just a few steps.

Find lead screw motors in just a few clicks: Simply enter your requirements and get matching results.

The motor gearboxes of the drylin E series are characterised by their low backlash, quiet running, high drive torques and an efficiency of 96%.

• Planetary gearbox for igus stepper motors NEMA 23 and 34
• Increased motor torque
• Higher holding torque of a brake
• Two installation sizes
• Reduction ratios of 3 & 5 available

The coupling connects the drive pin of the axle and the motor pin. An elastic plastic element in the centre of the coupling transmits the motor torque. Both radial and axial clearance are equalised by this dampening element.

• With square or round housing
• 20 versions in stock
• Vibration-dampening & pluggable
• Temperature range from -30°C to +100°C

Our switch-mode power supply units offer an optimum solution for supplying power to numerous electronic applications. Thanks to standardised installation in control cabinets on TS35 DIN rails or top-hat rails, you not only save space, but also valuable time.

• 8 versions in the online shop
• Rated power from 75 - 960W
• Ready to ship in 24h
• Suitable for igus motor controls

The right connection cable for every motor! In our online shop you will find cables for stepper, EC/BLDC and DC motors. The individual cables are categorised into motor cables, angular encoder cables and brake cables.

• Lengths of 3m, 5m, 10m or 20m
• Various outer materials
• Straight and angled connectors
• Available from stock